DRESSTA Co. Ltd. TD-15H — 4.18.1. DIGGING AND CLEARING

SECTION 4 OPERATING Page 34 OPERATING TECHNIQUES 4.18.1. DIGGING AND CLEARING WARNING! Prior to operating know the locations of gas lines, utility lines, sewers, overhead and buried power lines, and the other obstructions or hazards are known. A raptured gas line or cut electrical line could result in personal injury. Always feed the blade into the ground gradually until the desired depth of cut is obtained. When selecting the gear range and determining the depth of cut, allow for an increase in resistance as the load increases. When raising the blade at the end of a cut, do it gradually to avoid an abrupt ridge or bump in the path of the tractor.

Move material downgrade whenever possible to take advantage of the reduced effort required (Fig. 4.32). Fig. 4.32. Moving Material Downgrade Two methods of cutting down a pile or hill are shown in Fig. 4.33. Type of material and local conditions may dictate which method is preferred. Further information is included in “BREAKING PILES AND SPREADING”. When using Method l never allow the high face to become a hazard to the operator or machine. With the tractor at the right angle to the face, raise the blade and dislodge the high bank before returning to the original direction of cut. When using Method 2, make a cut wide enough to avoid trapping the tractor. Fig. 4.33.

Cutting Down a Pile or Hill 1. Method 1 2. Method 2 TD-15H DRESSTA