DRESSTA Co. Ltd. TD-15H — 4.18.1. DIGGING AND CLEARING

SECTION 4 OPERATING Page 36 OPERATING TECHNIQUES Once again, pushing loosened material to the lower side of the slope Fig. 4.36 will normally reduce time and cost. Do not push material beyond the point required to retain firm track support. Fig. 4.36. Slope Edge Operation Fig. 4.37. Operating a Tandem Arrangement When backing up, do not raise the blade as this puts extra weight on the front idlers causing greater track penetration. Let the blade float as you back away from the edge of soft fills. Initial work on steep hillsides can be safer by either securing the tractor with a winch to a suitable uphill anchor point or by operating a tandem arrangement as shown in Fig. 4.37.

When clearing trees, raise the blade high to gain leverage and make contact gently to reduce possible harm to the operator and machine (Fig. 4.38). Heavy roots of large trees may require pushing and digging or cutting from several sides of the tree. Use a cable to topple and remove trees from soft ground (Fig. 4.39). Fig. 4.38. Machine Equipped with Sweeps Fig. 4.39. Using Cable to Remove Trees CAUTION! Falling trees and dead limbs can cause injuries. When clearing trees, operator protection must be used. TD-15H DRESSTA