MAINTENANCE SECTION 5 Page 3 5.1. SERVICE PRECAUTIONS CAUTION! Only authorized personnel, thoroughly trained with the design and operation of all assemblies and mechanisms may be allowed to service this machine. WORK SAFELY – FOLLOW THESE RULES A CAREFUL OPERATOR IS THE BEST INSURANCE AGAINST AN ACCIDENT. GENERAL SERVICE PRECAUTIONS The procedures in this section contains many notes and precautions, which should be followed along with standard safety procedures to minimize the possibility of personal injury or improper service. Improper service could compromise the machine's safety or cause it to function improperly, which could result in personal injury or death.
Review the precautions listed in Section 2, “SAFETY PRECAUTIONS". Do not attempt to do repairs you do not understand. Use your "Service Manual" or consult your Authorized Distributor for information. Do not jump on or off a machine. When working under a machine or servicing in the area of the engine fan or belts, turn off the electric system master switch, apply and lock the parking brake and tag controls to warn against starting the machine. Whenever servicing, take care to prevent accidental cranking of the engine. Turn off the electric master switch and remove the key.
It is not possible to anticipate all conceivable ways or conditions under which a machine may be serviced or to provide precautions for all the possible hazards that may result. Safety is always the most important rule. Constantly be aware of dangers involved in working on a machine and take proper precautions. Standard and accepted safety precautions and equipment should be used. This machine is assembled using high strength fasteners. Do not substitute. Replacement fasteners must be of the same size and strength as the originals (refer to Section 6). Tighten fasteners to the proper torque value specified in Section 6, unless otherwise specified.
Refer to Spare Parts Catalogue for all replacement parts. Use safety goggles, hard hats, safety shoes, heavy duty gloves and other protection during cutting, grinding, chiseling, prying or any other process which could cause material removal or projectiles. Many machined parts are hardened and can chip. Use the proper size and type of tool for the job being done. Select a wrench that fits and be sure it is on straight. Keep your tools clean and in good condition. Some procedures require the use of tools specially designed for that specific purpose.
Before substituting another tool or procedure, you must be completely satisfied that neither personal safety nor the performance of the machine will be endangered. Scheduled maintenance is the normal maintenance necessary to provide proper and efficient equipment operation. DRESSTA TD-15H