DRESSTA Co. Ltd. TD-15H — 5.2. SCHEDULED MAINTENANCE GUIDE

MAINTENANCE SECTION 5 Page 5 SCHEDULED MAINTENANCE GUIDE 6. Lubricate gimbal crosstube. Refer to 5.14. 7. Replace hydraulic system return filter. Refer to 5.13.3. 8. Clean hydraulic reservoir breather. Refer to 5.13.5. 9. Clean transmission system suction strainer. Refer to 5.18.4.2. 10. Adjust engine valve lash. Refer to 5.11.3. 11. Check condition of fan hub and idler pulley. Refer to 5.11.4. and 5.11.5. 12. Check fan belt tension. Refer to 5.7.2.1. 13. Check sprocket bolts torque. Refer to 5.19.9. Periodic (at least once a year or as required) 1. Clean air cleaner elements or replace if necessary. Refer to 5.6. 2.

Lubricate hand and foot linkage, check for operation and adjust if necessary. Refer to 5.20. 3. Drain water and sediment from fuel tank sediment bowl. Refer to 5.12.5. 4. Clean fuel tank filler strainer. Refer to 5.12.2. 5. Clean the transmission scavenger strainer. Refer to 15.18.6. 6. Replace fuel strainer. Refer to 5.12.4.3. 7. Clean cab air filters. Refer to 5.21.1. 8. Check engine RPM with depressed decelerator. Refer to 5.20. 9. Check operation of brake lock. Refer to 5.20. 10. Check the condition of safety belt. Refer to 5.16. 11. Check undercarriage components for wear. Refer to 5.19.1. 12. Check track frames guide clearance and adjust if necessary, lubricate track frame guides.

Refer to 5.19.6. 13. Check clearance in blade socket and diagonal struts. Refer to 5.15.1.4. 14. Check condition and amount of charge of batteries. Refer to 5.10.3. 15. Check condition of electric wires and connections. Refer to 5.10.1. 16. Reverse fan blades (if equipped). Refer to 5.9. 17. Lubricate upper struts. Refer to 5.14. 18. Check torque: cab and ROPS mounting bolts. Refer to 5.21.2. track shoe mounting bolts. Refer to 5.19.2. blade cutting edge and end bit bolts. Refer to 5.15.3. trunnion cap bolts and trunnion mounting bolts. Refer to 5.15.2. 19. Check cutting edges and end bits for wear. Refer to 5.15.4. 20. Check ripper points for wear. Refer to 5.15.5. 21.

Measure and adjust the gap between equalizer bar and track frame rebound. Refer to 5.19.8. 22. Check front wheel guide clearance. Refer to 5.19.10. 23. Wash drive train compartment. Every 2000 Hours of Operation or 2 Years 1. Drain and flush cooling system. Change coolant. Refer to 5.8.8. 2. Change hydraulic system oil. Refer to 5.13.2., 5.13.6. 3. Clean hydraulic system suction strainer. Refer to 5.13.4. 4. Clean hydraulic reservoir filler strainer. Refer to 5.13.4. 5. Check condition of crankshaft vibration damper. Refer to Engine Operation and Maintenance Manual. DRESSTA TD-15H