Peterbilt Conventional Truck Series — Setting Ride Height

SUSPENSION WARNING! At least one of the mounting holes in the height control valve bracket will be slotted to permit rotating the valve. NOTE The rear of a vehicle will drop about 3 1/2 inches (88 mm) when the air springs are deflated. Ensure that no persons or objects that could be killed, injured or damaged are under the vehicle before deflating the air springs. 4. Rotate the valve either clockwise or counterclockwise until air pressure in the air springs provides the ride height specified for that suspension. Measure the ride height from the bottom of the frame rail to the approximate centerline of the rearmost drive axle hub:

On dual-valve systems, begin with the LH valve on the next step. For tandem axles, make the vertical measurement at the centerline of the suspension (see illustration on page 4-40). 3. Loosen the fasteners mounting a height control valve to its bracket. To minimize risk of death, personal injury or property damage, do not use a dump valve to deflate the air springs. Rotate the height control valve(s) manually to ensure positive control of air spring deflation. 4 For a single axle, make the measurement in front of the axle, in the area forward of the tires but not past the suspension bracket. 5.

When at the correct ride height, ensure that the height control valve lever is in the neutral position, then install either the built-in alignment pin or a 1/8-inch (3-mm) dowel (see illustration on page 4-40). To minimize risk of death or personal injury, keep away from air springs as they are being inflated. (03/17) Y53-6076-1B1 4-41