WARNING SYMBOLS Description of Warning Symbols 2. Axle, Traction Control (ATC or Automatic Traction Control) 3. Brakes, Anti-Lock Brake System (ABS) 1. Axle, Stability Control (ESC or Electronic Stability Control) Watches vehicle’s wheel speeds to detect slippage and may reduce engine power, or apply vehicle brakes, to help increase traction. Illuminates during the Instrumentation System Self-Test. Have the ABS system checked by an authorized dealer if the ABS Warning Lamp stays on for more than 3 seconds. Calculates the driver’s intended path of travel from wheel speed and steering angle sensors, then compares calculations to the actual direction of travel.
The system uses individual wheel brakes to re-adjust the path of the vehicle. Illuminates during the power-on self-test when the ignition is turned ON. It turns off after a few seconds if no system problems are detected. If an ATC problem is detected, the ATC warning lamp will turn on and stay on. 3 Illuminates during normal operating conditions to indicate a problem with the ABS System. See Operating the Brake System on page 4-21 for more information. Illuminates during the power-on self-test when the ignition is turned ON. It turns off after a few seconds if no system problems are detected. If an ESC problem is detected, the ESC warning lamp will turn on and stay on.
Illuminates when the ATC is regulating wheel spin and turns off after the traction control event has ended. Illuminates when a problem exists with the optional Wheel Spin Control feature. See Advanced ABS with Stability Control on page 4-25 for more information. Illuminates when the ESC system is regulating individual wheel brakes to correct the vehicle’s direction of travel. Flashes continuously when the ATC/Deep Snow & Mud switch is turned on, indicating that this feature is active. (03/17) Y53-6076-1B1 3-23