. MAINTENANCE SERVICE PROCEDURE CLEAN INSIDE OF COOLING SYSTEM WARNING The coolant has the important function of preventing corrosion as well as preventing freezing. Even in the areas where freezing is not an issue, the use of antifreeze coolant is essential. Komatsu machines are supplied with Komatsu Supercoolant (AF-NAC). Komatsu Supercoolant (AF-NAC) has excellent anticorrosion, antifreeze and cooling properties and can be used continuously for 2 years or 4000 hours. As a basic rule, we do not recommend the use of any coolant other than Komatsu genuine supercoolant (AF-NAC).
If you use another coolant, it may cause serious problems, such as corrosion of the engine and aluminum parts of the cooling system. To maintain the anticorrosion properties of Supercoolant (AF-NAC), always keep the density of Supercoolant between 30% and 68%. Supercoolant (AF-NAC) is already diluted with distilled water. When using coolant, investigate the lowest temperatures in the past and decide the density for the coolant from the coolant density table below. When actually deciding the density for the coolant, set it for a temperature 10 ° C (18 ° F) lbelow the actual temperature. The coolant density varies according to the ambient temperature, but it must always be a minimum of 30%.
Coolant density table 4 - 26 Immediat ely after the engine is stop ped, the coolant is at high t emperatu re and th e radiator i s under high i nternal pressure. If the rad iator cap is removed in thi s condition and th e water i s drained , it may c ause burns. To prevent this, w ait for the temperatu re to go do wn, then turn t he cap slowly to re lease the internal p ressure. Start the e ngine and fl ush the system . When standing u p or leavi ng the op erator's se at, se t the gear s hift l eve r to the N position and set th e parking b rake switch to the PARKING posit ion.
For detail s of starting the engine, s ee "OPERATIONS, CHECKS BEFORE STARTIN G (PAGE 3-83)" and "STARTIN G ENGINE (PAGE 3- 84)" in the O PERATION sec tion of the Operati on and M aintenanc e Manual When the undercover is removed, th ere is danger of to uching th Never go to the front of the machine when the engine i s running Stop the m achine on l evel ground when cleaning o r changi ng the co Clean the i nside of th e cooling sys tem, change the coolant accordin g to the table below Inte Antifreeze coolant rval for cleaning inside of cooling system and changing antifreeze coolant Komatsu supercoolant (AF-NAC) Every two years or every 4000 hours whichever comes first Minimum Temp °C Abov e -10 -15 -20 -25 -30 -35 -40 -45 -50 °F Abov e 14 5 -4 -13 -22 -31 -40 -49 -58 Concentration (%) 3 0 36 41 46 50 54 58 61 64