Komatsu — EVERY 6000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE and carry out the GREASING PROCEDURE FOR FRONT DRIVE SHAFT WARNING If grease hole (1) is not matched with grease fitting (2) of the spider, match them according to the following procedure. chocks 4 - 79 EVERY 6000 HOU Maintenance for every 50, 250, 500, 1000 , 2000 and 400 0 hours service should be carrie d out at the same t ime. LUBRICATE DRIVE When greasing, use greasing every 6000 h ours or every 2 yea 1. Using a grease p ump, pump in grease through the grease the arrows. fittings marked by 2. Grease the spider portion until grease come s out from the cap 3. seal. After greasing, wip e off any old grease that was pushed out.

When checking the positi ons of the grease hole s and grease fitt ings, ensure that the machine is stop It is very dangerous to ch eck the positions of th e grea se holes and greas e fittings while the machine Check that grease hole (1) of the A-frame ( at the rear of th e machine) is matched with greas e fitting (2) of the s pider 1. Move the machine forward or reverse. Do not go under th e machine at this ti 2. Stop the engine a under the tires. 3. Check that grease hole (1) is matched with grease fit If grease hole (1) i them by repeating