Komatsu — CAUTIONS WHEN USING REAR VIEW MONITOR

. ATTACHMENTS, OPTIONS USE OF REAR VIEW MONITOR SETTING OF REAR VIEW MONITOR CAUTIONS WHEN USING REAR VIEW MONITOR WARNING 6 - 39 HOW TO SET DISPLAY MODE A mark of "CAM1", "DI M", "IRIS" and "ZOOM" appears on the upper left side of the monitor display, dependin g on the sort of ongoing op eration. off in approx. 2 seconds after it lights up (2- second display mode). llowing operation to switch the display to the normal display. (Continuous display mode) Every mark is set to go off in approx. 2 seconds after it lights up (2- second di It is possible use the fo llowing operation to switch the display to the normal di splay. (Continuous display mo 1. Press mark switch same time.

A "Cam1" mark lig display, and the display mode. 2. When it is require press mark switch same time, the sa After a "Cam1" ma the upper left sid disappears, and th display mode. REMARK In both the 2-second d (2) while pressing manual switch (1) at the hts up on the upper left side of the monitor display mode changes to the continuous d to return to the 2- second display mode, (2), while pressing manual switch (1) at the me way as in step 1 above. rk remains lighted for approx. 2 seconds on e of the monitor display, only the mark e display mode changes to the 2- second isplay mode and continuous display mode, the time remaining until the mark and monitor ways displayed.

screen disappear is al Do not attempt to disa ssemble or modify the monitor. There is a danger of electric s hock or fire. Do not attempt to ope n the monitor backside cover. There is a danger of electric sh ock, as high voltage power is conducted internally. Do not use the monitor if it is suspected of defect. There is a fear of electric shock or f ire, should it be used in spite of a d efect. In that case, ask your Komatsu distributor for repair or replacement. In case a foreign mater ial has got into the monitor or it gets wet, or if a smoke comes out of the monitor or it gives a bad s mell, stop the use immediate Komatsu distributor. ly.

It poses a big danger to use the monitor when any such abn ormality exists. In that case, consult your , be sure to use one with the specified capacity of 3A. Should a fuse with a higher- than- specified n cause fire. When replacing a fuse capacity be used, it ca As a general rule, t his product should be replaced after a total usage tim e of approximately 3000 hours (or s. wrung the water out. approximately 3 yea rs), though this may differ according to usage condition When cleaning the monitor, use dry soft cloth or wet cloth after having well If it is very dirty, use neutral detergent. Do not use thinner or alcohol.

Sometimes an imag e on the monitor display is blurred due to the camera len s being smeared. In that case, c lean the camera lens wit h dry soft cloth or wet cloth after having well wrung the water out.