30. MACHINES READY FOR ATTACHMENT 30. MACHINES READY FOR ATTACHMENT Procedure for installation 1. Remove the bucket. For details of the procedure for removing the bucket, see “12.15 REPLACING AND INVERSION OF BUCKET”. 2. Place the attachment in a horizontal position, then install to the arm with pin A and then pin B . 3. After installing the attachment, stop the engine. Then operate each control lever and attachment control pedal to the front and rear, and left and right 2 or 3 times to the end of its stroke to release the remaining pressure inside the hydraulic circuit. Pin Pin 4.
After checking that the oil temperature is low, remove the blind covers from the inlet port and outlet port (2 places). AM092110 Be careful that no dirt or mud is stuck to the hose mouthpiece. If the O-ring is damaged, replace it with a new part. 5. Turn the rotor of the stop valves installed to the inlet and outlet piping at the side of the arm to the FREE position. Free 6. After installing the attachment, check the oil level in the hydrau- lic tank. AM092120 5-14