Komatsu — 31.2 ATTACHMENT INSTALLATION COMBINATION TABLE

31. INTRODUCTION OF ATTACHMENTS 31. INTRODUCTION OF ATTACHMENTS 31.2 ATTACHMENT INSTALLATION COMBINATION TABLE PC300, 300LC This table lists the combination of attachments which can be installed to the long arm (standard), short arm and extension arm. fi : Can be used : Can be used only for light-duty work x : Cannot be used NOTICE When the extension arm is equipped, if the bucket is drawn to the machine body, the arm interferes with the body. Operate the extension arm carefully. When the boom is fully lowered during oblique digging, the boom interferes with the undercarriage. Operate the boom carefully. Categories of use For general digging: digging or loading sand, gravel, clay etc.

For light duty digging: digging or loading dry, uncaked earth and sand, mud etc. For loading work: loading dry, loose earth and sand For digging or loading hard soil or soft rock, it is recommended that the strengthened bucket with high durability and high wear resistance be employed. *:

Equipped with side cutter 5-19 Name of bucket Capacity (m3) Outside width (mm) Use Standard Boom (6500 mm) HD Boom (6500 mm) Standard arm (3.2 m) Short arm (2.55 m) Short arm (2.2 m) Long arm (4.0 m) HD arm (3.2 m) * Narrow bucket 0.52 610 Narrow digging fi fi fi fi x * Narrow bucket 1.14 1145 Narrow digging fi fi fi fi x * Standard bucket 1.40 1340 General digging fi fi fi △ x * Light duty bucket 1.60 1510 Loading △ △ △ x x Light duty bucket 1.80 1700 Loading △ △ △ x x * Rock bucket 1.40 1310 Loading fi fi fi x fi Shape finishing bucket 0.40 – Shape finishing fi fi fi △ x Trapezoidal bucket 1.10 – Trapezoidal shape ditching fi fi fi △ x Ripper bucket 0.90 950 Digging rocks fi fi fi x fi One tooth ripper – – Digging, removing rocks fi fi fi x fi Three teeth ripper – – Digging, removing rocks fi fi fi x fi