OM7003 Cab Radio - Section 70 Page 70-3 PROGRAMMING PRESET STATIONS Presets are stations that are stored on each of the 6 push-buttons. After a station has been programmed into one of the preset buttons, pushing the preset provides a quick return to that station. The six but- tons can each store a preset channel per band. Perform the following steps for programming presets: OPERATION OF THE WEATHERBAND (U.S.) NOAA - Weather Radio is a service of the "Voice of the National Weather Service". It provides continu- ous broadcasts of the latest weather information directly from the National Weather Service offices.
Taped weather messages are repeated every four to six minutes and are routinely revised every one to three hours, or more frequently if needed. Most of the stations operate 24 hours, daily. 1. Turn the receiver ON. 2. Select the band and the desired station. 3. Press and hold one of the six push-buttons for at least 2 seconds. During the 2 second period, receiver output will be muted and the push-but- ton number will show on the display. When the station has been committed to memory, the audio and the preset icon will return. The weather for the area you are in may be found on one of 7 stations.
When in the Weatherband mode, the display will show the "WX" icon and "CHAN #" to indicate the channel. The channel may be adjusted through the TUNE /SEEK buttons, and may be pre- set as in the radio mode. The frequency associated with each channel is as follows: 4. Repeat steps 1 through 3 for the remaining available presets. NOTE: Six presets may be stored on AM, FM1, and FM2 for a total of 18 presets. 1. 162.550 MHz 5. 162.450 MHz 2. 162.400 MHz 6. 162.500 MHz 3. 162.475 MHz 7. 162.525 MHz 4. 162.425 MHz The National Weather Service operates approxi- mately 372 stations. Close to 90 percent of the nation's population is within the listening range of a NOAA Weather Radio broadcast.
ADJUSTING THE RECEIVER SETTINGS VOLUME: Rotate ON/AUDIO (6) knob clockwise to increase the volume and counter-clockwise to decrease the volume. "VOL" will be displayed along with the volume level. BASS: Push and release ON/AUDIO (6) knob until "BASS" and the current bass level is displayed. Rotate the knob clockwise to increase the bass and counter-clockwise to decrease the bass. TREBLE: Push and release ON/AUDIO (6) knob until "TREB" and the current treble level is displayed. Rotate the knob clockwise to increase the treble and counter-clockwise to decrease the treble.