Mitsubishi — Mitsubishi Diesel Engine Service Manual

FUEL SYSTEM - DISASSEMBLY, INSPECTION AND REASSEMBLY 2. Fuel Injection Pumps 2.1 Inspecting the fuel injection pump on vehicle Do not disassemble the fuel injection pump unless it is necessary. If the pump is suspected to be faulty, it is recommended that the entire pump assembly be replaced. 2.2 Disassembling the fuel injection pumps ① Tappet guide pin ② Lock plate ③ Tappet ④ Tappet adjusting shim ⑤ Spring lower seat ⑥ Plunger ⑦ Plunger spring ⑧ Spring upper seat ⑨ Control sleeve ⑩ Control rack ⑪ Delivery valve holder ⑫ O-ring ⑬ Delivery valve spring ⑭ Delivery valve gasket ⑮ Delivery valve ⑯ Plunger barrel ⑰ Pump housing Replace: O-ring Replace: Gasket Replace:

Lock plate Disassembly of the fuel injection pumps 3 - 13 Inspection item Description PASS criteria Low idle speed Inspect the low idle speed 1000±25 min-1 Exhaust gas color 1) Observe the exhaust gas color during no-load rapid acceleration 2) Observe the exhaust gas color under load No excessive black smoke Nozzle injection pattern To inspect the spray pattern, remove the nozzle from the engine and then place the nozzle outside by correcting the injection pipe. Crank the starter and check the spray pattern. Good spray pattern