Mitsubishi — Mitsubishi Diesel Engine Service Manual

FUEL SYSTEM - DISASSEMBLY, INSPECTION AND REASSEMBLY 3.2 Reassembling the governor (1) Install the levers first. (2) Install the O-ring onto the governor shaft. (3) Insert the governor shaft into the governor case, and combine it with the levers. (4) Hold the grooved pin and the spring pin in place, and knock them in with a soft hammer. (5) Install the tie-rod and the tie-rod spring. 3.3 Installing the torque spring set Prior to installation, adjust the low and high idle speeds of engine. Stop the engine for installation and adjustment of the torque spring set. (1) Remove the tie-rod cover. (2) Pull the speed control lever to the high idle speed position and hold it there.

(3) Pull the tie-rod in the direction of the arrow until a slight resistance is felt. Note: This is the initial resistance by the governor spring. Do not pull the tie-rod further to try to overcome the resistance. (4) While holding the tie-rod in this position, screw in the torque spring set until the notched line on the control rack is aligned with that on the pump body. (5) With both notched lines aligned, lock the torque spring set by tightening the special nut to the specified torque. (6) Place the torque set sealing cap over the torque spring set, and stake it in place.

Installing the levers Grooved pin Tie-rod spring Tie-rod Spring pin Assembling the governor Speed control lever Torque spring set Notched line on pump body Governor spring Notched line on control rack Installing the torque spring set Sealing cap Special nut Tightening torque: 14.7 to 24.5 N m (1.5 to 2.5 kgf m) [10.8 to 18.1 lbf ft] Governor lever Adjusting and sealing the torque spring set 3 - 21