Mitsubishi — Mitsubishi Diesel Engine Service Manual

ELECTRICAL SYSTEM - DISASSEMBLY, INSPECTION AND REASSEMBLY (5) Removing the center bracket Loosen the bolt and remove the center bracket. Behind the center bracket, there is a washer for adjusting the pinion shaft end play. (6) Removing the pinion (a) Place an appropriate tube on the pinion stopper. Tap the tube with a hammer to drop the pinion stopper to the clutch side. This will expose the stopper ring. (b) Using a pair of pliers, remove the stopper ring. Remove the pinion. Note: The stopper ring should not be reused on reassembly. (7) Removing the pinion shaft Pull out the spring, lever, reduction gear and pinion shaft from the front bracket. Note:

To facilitate reassembly, note the correct installations of the lever and the spring as they are removed. (8) Removing the bearings Using a bearing puller or other similar tool, remove the ball bearings at both ends of the armature. The ball bearing that has been press-fit into the front bracket cannot be replaced. If the bearing is worn or faulty, replace the entire front bracket assembly. Center bracket Adjusting washer Removing the center bracket Tube Stopper ring Spring Pinion Stopper ring Pinion stopper Removing the pinion Front bracket Pinion shaft Reduction gear Lever Spring Removing the pinion shaft 7 - 11