OVERHAUL TIMING 2. Measuring the Compression Pressure (1) Move the control lever to STOP position. (2) Remove the glow plugs from all cylinders. Install the special tool Compression Gauge Adapter and a compression gauge onto the cylinder being measured. Compression gauge Compression gauge adapter (3) While cranking the engine with the starter, read the compression gauge. Note the reading at which the gauge needle stabilizes. (4) If the measured value is at or below the limit, overhaul the engine. Measuring the compression pressure (a) Measure all cylinders for compression pressure.
Do not measure only one cylinder and make assumption about the other cylinders as this will lead to a wrong conclusion. (b) Compression pressure varies depending on the engine speed. Keep the specified engine speed when measuring the compression pressure. It is important to regularly check the compression pressure so that you can tell the difference. New or overhauled engines have slightly higher compression pressure. The compression pressure settles to the standard value as the piston rings and valve seats fit in. As wear progresses further, the compression pressure drops.
1 - 27 Special tool Part number Compression Gauge Adapter ST332270 Standard value Limit Engine speed 290 min-1 Compression pressure 2.9 MPa (30 kgf/cm2) [421 psi] 2.6 MPa (27 kgf/cm2) [377 psi] Tolerable difference between cylinders 0.29 MPa (3.0 kgf/cm2) [42 psi] or less