Mitsubishi — Mitsubishi Diesel Engine Service Manual

ENGINE MAIN PARTS - DISASSEMBLY 3. Cylinder Block, Crankshaft, Pistons, Oil Pan Piston ring wear, damage, Ring gap clearance Piston wear, seizure, streak, Ring groove wear Connecting rod bend, twist, Big end thrust clearance Cylinder damage, stepped wear Top face distortion Dirty or clogged oil and water galleries Damaged plugs and knock pins Crank journal/pin damage, uneven wear, cracks, bend, Clogged oil hole Damaged crankshaft gear teeth The main bearings may be seized due to poor oil maintenance etc. In that case, the crankshaft must be replaced. Caution Seizing Scoring Pealing Replace:

Side seal Disassembly of cylinder block, crankshaft, pistons and oil pan ① Oil pan ② Oil strainer ③ Connecting rod cap ④ Connecting rod bearing (lower) ⑤ Connecting rod ⑥ Piston pin ⑦ No. 1 ring ⑧ No. 2 ring ⑩ Piston (Remove ⑤ to ⑩ as an assembly.) ⑪ Connecting rod bearing (upper) ⑫ Main bearing cap ⑬ Main bearing (lower) ⑭ Crankshaft ⑮ Main bearing (upper) ⑯ Cylinder block ⑨ Oil ring Note: If the crankcase is to be replaced, carefully remove the relief valve and other parts from the old crankcase for reassembly onto the new crankcase. 2 - 12