6-46 Item Description Service action Bucket rollback circuit relief valve check Position bucket at a 45˚ angle against an immovable object. Engage transmission in 3rd speed forward. LOOK : Bucket angle must not change. OK Check complete. NOT OK Replace boom lower check valve. Bucket dump circuit relief valve low pressure check Raise front of machine which bucket at 45˚ angle. Backdrag with bucket while observing bucket angle. LOOK : Bucket must not rollback OK Go to next check. NOT OK Do loader system and circuit relief valve test at page 6-60. Pilot control valve float check Run engine at low idle. With the bucket partially dumped, lower boom to raise front of machine.
Push control lever to the float detent position and release lever. LOOK : Front of machine lower to the ground and valve must remain in float position when lever is released. OK Check complete. NOT OK Do pilot control valve pressure test in group 3. Boom cylinder and bucket cylinder drift check Heat hydraulic oil to operating temperature. B Set the boom and bucket horizontal, then stop the engine. Stop the engine, wait for 5 minutes, then start measuring. Measure the amount the lift and B dump cylinder rods retract during A 5 minutes. (unloaded bucket) A : Retraction of boom cylinder rod B :
Retraction of bucket cylinder rod Boom cylinder must drift less than 8 mm A Bucket cylinder must drift less than 13mm (侏15mm) OK Check complete. NOT OK Go to next check. 侏HL940TM