2. TROUBLESHOOTING 2. TROUBLESHOOTING ц Diagnose malfunction charts are arranged from most probable and simplest to verify, to least likely, more difficult to verify. Remember the following steps when troubleshooting a problem : Step 1. Operational check out procedure (see section 1) Step 2. Operational checks (see group 2) Step 3. Troubleshooting Step 4. Tests and adjustments (see group 3) 6-50 Problem Cause Remedy Noisy hydraulic pump Low oil supply or wrong viscosity. Plugged or pinched suction line. Air in oil. Plugged suction strainer. Loose or missing hydraulic line clamps. Hydraulic lines in contract with frame. Worn or damaged pump. Fill reservoir with recommended oil.
Clean or replace line. Check for foamy oil. Tighten connections. Replace O-rings and or lines. Inspect and clean strainer in reservoir. Tighten or replace clamps. Inspect and repair. Do hydraulic pump performance check in group 2. Do hydraulic pump flow test in group 3. No or Slow hydraulic functions Failed or worn hydrualic pump. Cold oil. Slow engine speed. Suction line air leak. Low oil supply. Wrong oil viscosity. Oil leaking past cylinders or control valve. Blocked or damaged line. Faulty pilot control valve (RCV). Binding loader control valve (MCV) spool. Faulty steering unit. Do performance check. Warm oil up. Adjust engine speed. Check high idle speed. Check for foamy oil.
Add recommended oil. Use recommended oil. Check cylinder drift in group 2. Inspect lines. Do pilot control valve (RCV) pressure test in group 3. Inspect valve. Check steering unit specification.