SERVICE PROCEDURE MAINTENANCE. CHECKING COOLANT LEVEL REMARK Check the coolant level before starting the engine. 1. Check the coolant level in the radiator reserve tank (5). The coolant level should be between the FULL and LOW mark- ings on the tank. 2. If coolant must be added, remove the reserve tank cap (4) and add coolant until level is between the FULL and LOW markings on the tank. Full Low DRAINING THE SYSTEM Before working on the engine or electrical system, dis- connect the negative (ground) battery cable. Tag the cable and controls to warn against starting. Wear hand and eye protection when draining hot fluids. 1.
Run the engine until it reaches operating temperature; then stop the engine 2. Remove the radiator cap as outlined in this section. 3. Remove the crankcase coolant drain plug located on the bot- tom of the coolant inlet (1). 4. Open the radiator drain valve (2). 5. Allow the system to completely drain into a suitable container. Do not let drain outlets plug up during draining. 6. Close the radiator drain valve (2). Install the crankcase cool- ant drain plug (1). CLEANING THE SYSTEM At 2000 hours clean the cooling system as follows: 1. Drain the system into a suitable container. Refer to “DRAIN- ING THE SYSTEM” on page 196. 2. Drain and clean the reserve tank. 3.
Close the radiator and crankcase drains. 196 WARNING