Komatsu — GENERAL LOCATIONS

MACHINES READY FOR ATTACHMENTS OPTIONS, ATTACHMENTS 1. STOP VALVE (1) This valve stops the flow of the hydraulic oil. (1) FREE: Hydraulic oil flows. (2) LOCK: Hydraulic oil stops. When removing or installing attachments, set this valve to the LOCK position. 2. SELECTOR VALVE (2) This switches the flow of the hydraulic oil. Position (1): When breaker is used Position (2): When general attachment is used (crusher, etc.) 3. RH WRIST CONTROL BUTTONS These are used to operate the attachment. Button 1 delivers oil down the LHS of the work equipment. Button 2 delivers oil down the RHS of the work equipment. See also "Handling the clamshell bucket" and "Operation when using breaker" 4.

ACCUMULATOR (FOR CONTROL CIRCUIT) (4) The accumulator is charged with high-pressure nitrogen gas, and it is extremely dangerous if it is handled mistakenly. For details of handling, see “HANDLING ACCUMULA- TOR” on page 250. This is installed to release any remaining pressure in the attach- ment circuit after the engine is stopped. Normally, do not touch it. 246 A To/from main valve B 1 way flow to tank (breaker) C To tank D 2 way flow position (normal) E From boom piping WARNING