GENERAL / Tightening Quick Coupler 1. Coupling procedure Push socket ring (1) into plug (3) by rotating it fully counterclockwise and then pulling it toward you. Release socket ring (1). Check that socket ring (1) is returned by the spring force and the coupling is locked completely by ball (2). At this time, check if socket ring (1) is returned to the original position (to the rightmost direction). 2. Separating procedure Remove the hose by rotating socket ring (1) fully counterclockwise and then pulling it. Because no check function is attached inside, be careful that oil flows out. Cap the removed hoses using special plug. 3 1 2 M1M7-07-006 CAUTION:
When disconnecting, do not damage joint surface. When disconnecting, clean the joint part and thoroughly wipe off the cleaning solution to prevent any foreign material from entering. Complete the joint disconnecting / connecting procedure. Check enough if oil leaks especially after installation. After installation, check if socket ring (1) is returned to the original position (to the rightmost direction). W1-2-6