GENERAL / Preparation PREPARATIONS FOR INSPECTION AND MAINTENANCE CAUTION: If ride control switch (1) is kept ON, the lift arm may unexpectedly rise. To avoid an accident due to unexpected movement of the lift arm, always turn ride control switch (1) OFF before beginning the inspection and/or maintenance of the machine. CAUTION: If the machine is unexpectedly moved, a serious accident may result in. Be sure to apply the parking brake when parking the machine. Unless specially specified, park the machine by following the procedures below before beginning the inspection and/or maintenance work. 1. Park the machine on a level surface. 2. Lower the bucket to the ground. 3.
Turn rid control switch (1) OFF. 4. Turn forward / reverse lever (2) NEUTRAL. Set neutral lever lock (3) to the LOCK position. 5. Turn parking brake (4) ON. 6. Wedge the tires. 7. Set the key switch to the OFF position. Stop the engine. Remove the key from the key switch. If maintenance should be performed with the engine running, do not leave the machine unattended. 8. Set front control lever lock (2) to the LOCK position. 9. Install articulation lock bar to securely lock and prohibit movement between the front and rear frames. 10. Before performing any work on the machine, attach “UNDER INSPECTION / MAINTENANCE” tag on the door or control lever.
M4FJ-01-004 ON OFF M4GB-01-085 M4GB-01-004 4 ON OFF M4GB-01-154 W1-6-1 Loc 5 1 k UnLock 1 3 4 2