Page4 ~ Safety precautions THESE SAFETY PRECAUTIONS ARE IMPORTANT. Reference must also be made to the local regulations in the country of operation. Do not use these engines in marine applications. Do not change the specification of the engine. Do not smoke when you put fuel in the tank. Clean away any fuel which has fallen and move material which has fuel contamination to a safe place. Do not put fuel in the tank during engine operation (unless really necessary). Never clean, lubricate or adjust the engine during operation (unless you have had the correct training when extreme caution must be used to prevent injury). Do not make any adjustments you do not understand.
Ensure the engine is not in a position to cause a concentration of toxic emissions. Persons in the area must be kept clear during engine and equipment or vehicle operation. Do not permit loose clothing or long hair near parts which move. Keep away from parts which turn during operation. Note that fans can not be seen clearly while the engine is run. Do not run the engine with any safety guards removed. Do not remove the radiator cap while the engine is hot and the coolant is under pressure as dangerous hot coolant can be discharged. Do not use salt water in the cooling system or any other coolant which can cause corrosion.
Keep sparks or fire away from batteries (especially during charge) or combustion can occur. The battery fluid can burn and is also dangerous to the skin and especially the eyes. Disconnect the battery terminals before you make a repair to the electrical system. Only one person must be in control of the engine. Ensure the engine is only operated from the control panel or operators position. If your skin comes into contact with high pressure fuel, get medical assistance immediately. Diesel fuel can cause skin damage to some persons. Use protection on the hands (gloves or special skin protection solutions). Do not move equipment unless the brakes are in good condition.
Ensure that the transmission drive control is in "Out of Drive" position before the engine is started. Fit only correct Perkins Parts.