CAUTIONS AFTER COMPLETION OF WORK To prevent mud, water, or the undercarriage from freezing and making it impossible for the machine to move on the following morning, always ob- serve the following precautions. 0 Mud and water on the machine body should be completely removed. This is to prevent damage to the seal caused by mud or dirt getting in- side the seal with frozen drops of water. 0 Park the machine on concrete or hard ground. If this is impossible, park the machine on wooden boards. 0 Drain water collected in fuel system so that such water may be frozen at night.
0 As battery capacity drops at low ambient temperature, cover the battery or remove it from the machine to be kept warm at night. AFTER COLD WEATHER When weather becomes warm, perform the following without fail: l Replace lubricating oils for various units with the ones specified for warm-weather use. l If for any reason permanent antifreeze connot be used, and an ethyl gly- col base antifreeze (winter, one season type) is used instead, or if no antifreeze is used, drain the cooling system completely, then clean out the inside of the cooling system thoroughly, and fill with fresh water. PREPARING THE CAB HEATER If the ambient temperature drops, use the cab heater.
When using the cab heater, turn valve (1) on the water manifold counter- clockwise to open it. * When leaving the cab heater unused for a long time, turn valve (1) clock- wise to close it. - 106-