Komatsu — PRECAUTIONS WHEN DISASSEMBLING MACHINE

PRECAUTIONS WHEN DISASSEMBLING When disassembling the machine or removing piping for inspection or maintenance, always release the remaining pressure as follows. A. RELEASING PRESSURE IN WORK EQUIPMENT CIRCUIT, SWING CIRCUIT, TRAVEL CIRCUIT Lower the work equipment to the ground on a firm, flat surface as shown in the diagram, then stop the engine. Set the lock lever to the FREE position. Operate all the work equipment levers to the end of their travel within 5 - 6 seconds of stopping the engine. Remove the cap from the hydraulic tank. Start the engine, run for approx. 10 seconds, then stop the engine. Do not run the engine at above 1000 rpm. Place the work equipment levers at neutral.

Operate all the work equipment levers to the end of their travel within 5 - 6 seconds of stopping the engine. Repeat Steps 4 - 5 three times. A When removing the oil filler cap from the hydraulic tank, turn it slowly to release the internal pressure, and remove it carefully. 1. * 2. 3. 4. * * 5. sr B. RELEASING PRESSURE FROM ACCUMULATOR CIRCUIT 0 Pilot circuit After stopping the engine, place lock lever (I) in the FREE position, oper- ate all the work equipment levers 3 - 4 times to the end of their travel, then wait for at least 1 minute for the pressure to be released. * Do not loosen any piping for at least 1 minute after releasing the pressure. - IIO-