b. Start engine Start the engine (see OPERATING YOUR MACHINE) and run at low idling for 10 minutes, before going on to the next operation. c. Bleeding air from cylinders 1. Run the engine at low idling, and extend and retract each cylinder 4 - 5 times without operating it to the end of its stroke. (Stop approx. 100 mm before the end of the stroke) 2. Next, operate each cylinder to the end of its stroke 3 - 4 times. 3. After this, operate each cylinder 4 - 5 times to the end of its stroke to completely bleed the air.
* If, at first, the engine is run at high speed or the cylinder is operated to the end of its stroke, the air inside the cylinder may cause damage to the piston packing or other parts. d. Bleeding air from swing motor 1. Run the engine at low idling, loosen air bleed plug (I), and when no more cloudy white oil flows out from air bleed plug (I), tighten the plug. t Tightening torque: 7.0 + 1.0 kgm t When doing this, do not operate the swing. 2. Run the engine at low idling, and swing 2 or more times slowly and uni- formly to the left and right. t If the air is not bled from the swing motor, the bearings of the motor may be damaged. e. Bleeding air from travel motor 1.
Run the engine at low idling, loosen air bleed plug (I), and when no more cloudy white oil flows out, tighten the plug. * Tightening torque: 0.9 + 0.1 kgm 2. Keep the engine running at low idling, and swing the work equipment 90” to bring it to the side of the track. 3. Jack up the machine until the track is raised slightly from the ground. Ro- tate the track under no load for 2 minutes. Repeat this procedure on both the left and right sides, and rotate the track equally both forward and in reverse. f.
Start operations After completion of bleeding the air, stop the engine, and wait for at least 5 minutes before starting operations, In this way, the air bubbles are removed from the oil inside the hydraulic tank. t Check for any leakage of oil, and wipe off any oil that has been spilled. -114-