Komatsu — EVERY 250 HOURS SERVICE

EVERY 250 HOURS SERVICE Carry out the following maintenance only after the first 250 hours. 0 FUEL FILTER, REPLACE CARTRIDGE . ENGINE VALVE CLEARANCE, CHECK AND ADJUST For details of the method of replacing or maintaining, see the section on EVERY 500 HOURS AND 2000 HOURS SERVICE. a. FINAL DRIVE CASE 1. Set with the UP mark at the top, and with the line connecting the UP mark and plug (P) perpendicular to the ground surface. 2. Remove plug (F), and if the oil is not within 10 mm below the bottom of the plug hole, install plug (F), rotate the sprocket one turn, then check again. If the oil is still not within 10 mm below the bottom of the plug hole, add engine oil through the plug hole.

* The type of lubricant used depends on the ambient temperature. Select according to the table “FUEL, COOLANT AND LUBRICANTS”. b. ENGINE OIL PAN AND FILTER 1. Pull down the lever on drain valve (P) under the chassis to drain the oil. After draining the oil, push up the lever and close the valve. 2. Using a filter wrench, remove cartridge (1) of the engine oil filter by turn- ing it counterclockwise. 3. Clean the filter holder, coat the packing surface and thread of a new filter cartridge with clean engine oil (or coat it thinly with clean grease), then install.

t When installing, tighten until the packing surface contacts the seal surface of the filter holder, then tighten 3/4 to 1 of a turn. 4. After replacing the cartridge, pour in the specified quantity of engine oil through oil filler (F). 5. Run the engine at idling for a short time, then stop the engine and check that the oil level is correct. For details, see CHECK BEFORE STARTING. * Refill capacity: 25 II * The type of lubricant used depends on the ambient temperature. Select according to the table “FUEL, COOLANT AND LUBRICANTS”. * Be sure to fit a genuine Komatsu cartridge.

* Even if the machine has not been operated for 250 hours, the oil and fil- ter cartridge must be replaced when the machine has been operated for 6 months. In the same way, even if the machine has not been operated for 6 months, the oil and filter cartridge must be replaced when the machine has been operated for 250 hours. * When supplying oil, be careful not to get oil on the alternator. * If filter cartridge (1) is removed immediately after stopping the engine, oil will spill. Wait at least 10 minutes after stopping the engine before replac- ing the filter cartridge. - 132-