Komatsu — EVERY 250 HOURS SERVICE

* Use API category CD class oil. If CC class oil must be used, change the oil and replace the oil filter at half the usual interval. c. FAN BELT 1. The belt tension should normally deflect by 3 mm (a) when pressed with the finger at a point midway between alternator pulley (b) and fan pulley (c) (approx. 6 kg). (d): Crankshaft pulley 2. To adjust the belt tension, loosen bolts and nut (I), (2), (3) and shift alter- nator (4) slightly. 3. After adjusting, tighten bolts and nut (I), (2), and (3) to the specified torque. * Tightening torque Bolt (I), (2): 6.75 + 0.75 kgm Bolt (3) :

11.75 f 1.75 kgm * When adjusting the V-belt, do not attempt to push alternator (4) directly with a bar or the like, but use a wood pad to prevent damage to the core. * Check each pulley for damage, and V-grooves and V-belt for wear. Par- ticularly, check whether V-belt is in contact with bottom of V-groove through wear. * Replace belt if it has stretched, leaving no allowance for adjustment, or if there is a cut or crack on belt. d. HYDRAULIC FILTER 1. Remove the cap from oil filler (F). 2. Remove cover (I), then remove spring (2) and valve (3), and take out element (4). 3. Clean the parts after taking them out, then install a new element.

A When removing the cap, turn it slowly to relieve inner pressure. A When removing the cover (I), undo the bolts (4 bolts) gradually to pre- vent the cover flying off under the force of the spring (2). or When a hydraulic breaker is installed, the hydraulic oil deteriorates faster than for the normal bucket excavation work, so always install the extra filter specified by Komatsu. * For installation of extra filters, please contact your Komatsu distributor. * Replace the extra filters on new machines after the first 250 hours, and following this, replace at the intervals shown in the table below. (a): Replacement interval (h) (b): Breaker operation rate (%) (c):

Replacement interval for main filter (d): Replacement interval for extra filter - 134-