e. SWING CIRCLE Lubricate to the 3 grease fittings shown by an arrow. f. BATTERY ELECTROLYTE If the electrolyte level is lower than the prescribed level (10 to 12 mm above the plate), supply distilled water. * Should any of the acid be spilt, have it replenished by the nearest battery shop with acid of the correct specific gravity. t When inspecting electrolyte level, clean the air hole of the battery cap (1). A If the electrolyte gets on your skin or clothes, immediately wash with plenty of clean water. A To avoid gas explosions, do not bring fire or sparks near the battery. g. WATER PUMP BELT 1. The deflection (a) should be 6 mm when pushed with a thumb pressure of approx. 6 kg.
midway between water pump pulley (b) and fan pulley (c). (d): Crankshaft pulley 2. Loosen locknut (I), and bolts (2) and (3), then adjust the belt tension with adjustment bolt (4). 3. After adjusting, tighten bolts (2) and (3), turn back adjustment bolt (4) l/2 turns, then tighten locknut (1). * Tightening torque Locknut (1): 3.15 f 0.35 kgm Bolt (2), (3): 6.75 + 0.75 kgm - 136-