h. FUEL FILTER Loosen the drain plug at the bottom of the fuel filter, and drain the water and sediment collected at the bottom together with fuel. t If air has been sucked in by mistake, bleed the air. For details, see RE- PLACING FUEL FILTER CARTRIDGE. i. HYDRAULIC TANK BREATHER A When replacing the breather, turn oil filler (F) slowly to release the in- ternal pressure first. 0 Replacement of filter element of breather (1) 1. Remove cap nut (2), nut (3), seal washer (4), and cover (5). 2. Replace filter element (6) with a new element, then install cover (5), seal washer (4). nut (3), and cap nut (2) in order. * Install the filter element with the sponge packing at the top.
* Align the notched portions of, body (7) and cover (5), then install and lock in position. (a): Notch * Tightening torque Cap nut (2), nut (3): 1.2 f 0.2 kgm l Replacement of element of cap (F) 1. Remove bolt (8) and cover (9). 2. Replace filter element (10) with a new element, then install cover (9) and bolt (8). t When installing cover (9), check that the male and female portions inside are aligned. * Tightening torque of bolt (8): 0.8 + 0.1 kgm - 138-