e. CORROSION RESISTOR 1. Screw in valve (1) at the top of the corrosion resistor. 2. Using a filter wrench, turn cartridge (2) to the left and remove it. 3. Coat the packing surface and thread of a new cartridge with clean engine oil. * When installing, bring the packing surface into contact with the seal sur- face of the filter holder, then tighten about 213 of a turn. 4. Open valve (1). * Use a genuine Komatsu cartridge. 5. Start the engine and check that there is no leakage of water from the seal surface. - 146-