b. HYDRAULIC TANK STRAINER I. Remove the cap of oil filler (F). 2. Remove cover (1) and lift up the top of rod (3) from above to take out spring (2) and strainer (4). 3. Wash the strainer with fuel oil. If strainer (4) is damaged, replace it with a new one. 4. Refit strainer (4) by inserting it into tank projecting part (5). A When removing the cap, turn it slowly to relieve inner pressure. A When removing cover (I), undo the bolts (4 bolts) gradually to prevent the cover flying off under the force of spring (2). c. FINAL DRIVE CASE 1. Set with the UP mark at the top, and with the line connecting the UP mark and plug (P) perpendicular to the ground surface. 2.
Drain the oil from drain plugs (P) on both sides of the machine. After draining, tighten the drain plugs. 3. Then, supply new engine oil through oil filler (F) respectively to the speci- fied level. (Refer to EVERY 250 HOURS SERVICE.) * The type of lubricant used depends on the ambient temperature. Select according to the table “FUEL, COOLANT AND LUBRICANTS”. * Refill capacity PC300,3OOLC: 7.4 P (each) PC300HD : 11 P (each) d. ENGINE BREATHER 1. Loosen the clamp, and remove the hose, then remove breather (1) from the cylinder head cover. 2. Wash the breather unit in diesel oil or flushing oil, dry with compressed air, then install it again. 3.
Check the breather hose, and if any deteriorated oil (sludge) is stuck to the inside, replace it with a new hose. Sr Before removing the breather, remove all the dust from around the breather. * Replace the breather o-ring with a new part, coat with engine oil, then in- stall. -150-