Replacing inner element 1. Remove the outer element, and then remove the inner element. 2. Cover the air connector with a clean cloth or tape. 3. Clean inside the body, then remove the cover fitted in Step 2. 4. Install the new inner element. 5. After installing the new outer element, return the red piston in the dust indicator to its original position. * Do not attempt to reinstall a cleaned inner element. A Do not clean or replace the air cleaner element with the engine running.
Cleaning the outer element With compressed air Direct dry compressed air (less than 7 kg/cm2) to the element from inside along its folds, then direct it from outside along its folds and again from inside, and check the element. A When using compressed air, wear safety glasses and other things required to maintain safety. The following methods require spare parts. With water Dash city water (less than 3 kg/cm2) on the element from inside along folds, then from outside and again from inside. Dry and check it.
With cleaning agent For removing oils and fats as well as carbon, etc., attached on the ele- ment, the element may be cleaned in lukewarm solution of mild detergent, then rinsed in clean water and left to drip dry. Sr Drying can be speeded up by blowing dried compressed air (less than 7 kg/cm2) from the inside to the outside of the element. Never attempt to heat the element. * Using warm water (about 40°C) instead of soapy water may also be effec- tive. * If small holes or thinner parts are found on the element when it is checked with an electric bulb after cleaning and drying, replace the ele- ment. * Do not use an element whose folds or gasket or seal are damaged.
t When cleaning the element, do not hit it or beat it against something. - 160-