c. CHECK TRACK TENSION The wear of pins and bushings on the undercarriage will vary with the working conditions and soil properties. It is thus necessary to continually inspect the track tension so as to maintain the standard tension on it. If the track tension is not at the standard value, adjust it in the follow- ing manner: Inspection 1. Raise the chassis with the boom and arm. 2. The standard clearance between the bottom of the track frame and the top surface of the track shoe is 331 rt 20 mm (PCBOOHD: 358 + 20 mm). (a): Track frame (b): Track shoe * Places to measure PC300-5, 5 MIGHTY, 300HD: 4th track roller from sprocket PC3OOLC-5, 5 MIGHTY:
Between 4th and 5th track roller from sprocket Adjustment If the tension is not the standard value, adjust as follows. 1. To increase the tension, pump in grease through grease fitting (1); to re- duce the tension, loosen plug (2) a little at a time, and release the grease. A Plug (2) is under high pressure from the grease inside, and may fly out, so do not loosen it more than one turn. When doing this, do not loosen any part other than plug (2). If the grease does not come out properly, move the machine backwards and forwards slightly. 2. When pumping in the grease, make S 0 mm.
If the tension is still loose, it means that there is excessive wear of the pin and bushing, so it is necessary to turn or replace the pin and bushing. Please contact your Ko- matsu distributor for repairs. - 162-