h. CLEAN LINE FILTER If there is any abnormality in the pump or other hydraulic equipment, remove the dirt from inside the line filter as follows. * Before removing the line filter, release the pressure inside the hydraulic circuit. For details, see PRECAUTIONS WHEN DISASSEMBLING MACHINE. 1. Remove case (I), then remove element (2) and clean it. * Some of the oil inside the piping will come out, so prepare a container to catch it. Sr Remove the dirt stuck inside the case. 2. Install element (2), then screw in case (1) to install it. t Replace o-ring (3) and backup ring (4) as a set when reassembling. * Tightening torque Case (1):
4.5 f 0.5 kgm * After reassembling the line filter, bleed the air from the circuit. For de- tails, see BLEEDING AIR FROM CIRCUIT. i. DRAIN WATER FROM WATER SEPARATOR When float (2) is at or above red line (I), drain the water according to the following procedure: 1. Loosen drain plug (3) and drain the accumulated water until the float reaches the bottom. 2. Tighten drain plug (3). 3. If the air is sucked into the fuel line when draining the water, be sure to bleed the air in the same manner as for the fuel filter. (See Fuel Filter Cartridge in EVERY 500 HOURS SERVICE section.) - 170-