The engine oil pressure monitor does not light up when engine is station- ary (when the starting switch is in ON position.) 0 Replace the monitor. l Replace the caution lamp switch. Charge monitor does not light up when the engine is stationary. (When the starting switch is in ON position.) 0 Replace the monitor. 0 Check and repair the wiring. ENGINE The engine oil pressure monitor flashes when engine speed is raised after completion of warm-up. 0 Add the oil to the specified level. 0 Replace the filter cartridge. 0 Check oil leakage from the pipe or the joint. l Replace the monitor. Steam is emitted from the top part of the radiator (the pressure valve).
The radiator cooling water level monitor flashes. 0 Supply the cooling water and check leakage. 0 Adjust fan belt tension. 0 Wash out inside of cooling system. 0 Clean or repair the radiator fin. l Replace the thermostat. 0 Tighten the radiator cap firmly or replace the packing of it. l Replace the monitor. The engine does not start when the starting motor is turned over. l Add fuel. 0 Repair where air is leaking into fuel system. l Replace the injection pump or the nozzle. 0 Check the valve clearance. l Check engine compression pressure. l Refer to the section of electrical system. Exhaust gas is white or blue. l Adjust to specified oil quantity. l Replace with specified fuel. - 175-