Komatsu — SAFETY HINTS

DURING OPERATION 1. Maintain the bucket at a height of 40 to 50 cm above the ground so that it can be quickly lowered to the ground and the machine stopped in an emergency. 2. As far as possible, operate the machine so that it does not tilt. (Do not tilt it by more than 35” in either the forward, rear, left or right direc- tions, even under static conditions.) 3. Always operate slowly in crowded places. On haul roads or in narrow places, give way to loaded vehicles. 4. Do not allow unauthorized persons into the work area. 5. Before reversing or turning, ensure that there is nobody in the vicinity. Also, be careful of obstacles. 6.

When operating on slopes, as far as possible, avoid turning the machine on a slope. It may cause the machine to roll over or slip sideways. 7. When operating the machine along a road, retract the work equipment to improve machine stability. As far as possible proceed along a fiat road. 8. The machine should always be operated at a speed where it can be correctly controlled. Never do the following: 1) Speeding 2) Sudden starting, sudden braking, sudden turning. 3) Snaking 4) Coasting 9. When operating on uneven ground or in places where there are obsta- cles, remember the following points: * Operate at as low a speed as possible and avoid sudden changes in direction.

* Wherever possible, avoid traveling over large rocks, fallen trees, tree stumps and other such ,obstacles. Either use the work equipment to remove them, or travel round them. When it is impossible to avoid traveling over them, reduce speed and mount over the obstacle. Just before the front of the machine tips down, reduce speed even more to make the shock of hitting ground as small as possible. t Never mount over an obstacle at an angle; never disengage one tra- veling and steering lever to travel over an obstacle. 10. The machine condition can be judged from many factors.

Changes in the gauges, sound, vibration, exhaust gas color or response of the con- trol levers can indicate the occurrence of some disorder. If any disorder occurs, park the machine immediately in a safe place and take appropri- ate action. Be especially careful in the case of a fuel leak as there is danger of fire. 11. The work area should be made as flat as possible. If the work area is flat, operation is made much easier and this reduces operator fatigue. -8-