22. When operating in water or when crossing shallows, first check the bed soil condition and the depth and flow speed of water, then proceed, tak- ing care not to go beyond the permitted depth. t First check the water depth, the firmness of the ground and the strength of the current. Do not enter if the water exceeds the permis- sible depth (up to the bottom of the swing circle). When operating in fog, mist or smoke, where visibility is bad, be espe- cially careful to confirm first whether operation is safe. When visibility drops below safety level, stop work and wait for the visibility to improve. When operating at night, remember the following points:
Sr Be sure to arrange an adequate lighting system. * At night it is very easy to make mistakes in assuming the distance and height of objects and land. Be very careful not to touch electric wires, always bearing in mind that there is a possibility of receiving an electric shock. * Wear rubber or leather soled shoes. t Position a full-time watcher at the site to ensure that operator is not exposed to the risk of electric shock. Depending upon the supply voltage it is conceivable that an electric shock may be received by merely coming into the vicinity of an electric feeder wire.
Accordingly, observe the minimum distances given in the table below, taking into account the inertia of the boom when in motion. 23. 24. 25. * Minimum safe (number of insulators) separation Supply voltage I * Become familiar with the necessary measures to be taken in the event that a operator receives an electric shock. Do not perform excavation at the bottom of a precipice as it is danger- ous practice. If it is unavoidably necessary to operate the work equipment lever when traveling the machine in the vicinity of a precipice, road shoulders, on sloping ground or through a confined space, stop the machine momen- tarily before operating the work equipment lever in order to minimize danger.
When working on loose, crumbly soil, do not dig deeply and back the machine off smartly. If the ground crumbles, preventing the machine from getting away in time, do not panic and raise the work equipment. It is often better in the interests of stability to leave it down. 26. 27. 28. - 12-