Komatsu — LOCKING CAP

LOCKING CAP Locks are installed to the fuel tank filler cap, hydraulic tank filler cap, operator’s cab, left side door (rear), and engine hood. * Use the starting key to open and close the cap. A. METHOD OF OPENING AND CLOSING FUEL TANK FILLER CAP 0 To open the cap 1. Insert the key into the cap. (a): OPEN (b): LOCK 2. Turn the key clockwise, align the match mark on the cap with the rotor groove, then remove the cap. 0 To lock the cap 1. Turn the cap into place. 2. Turn the key counterclockwise and take the key out. or Insert the key as far as it will go. If the key is turned before it is inserted all the way, it may break. (c): Shoulder B.

METHOD OF OPENING AND CLOSING HYDRAULIC TANK FILLER CAP 1. Insert hexagon wrench (1) (4 mm) into the hole at the side of the side block. 2. With the wrench turned to the outside, turn the cap counterclockwise approx. 30”. Stop here to, release the pressure, then turn fully and remove the cap. 3. When closing the cap, align the cap with protrusion (2) on the case, then screw in the cap clockwise until it locks. A When removing the cap, always use a hexagon wrench to release the lock before opening it. - 22 -