CHECKING AND MAINTAINING CAR COOLER a. Checking coolant level If the cooling effect is poor, check the side glass (liquid eye) of the receiver drier. If there are many bubbles, the coolant level is too low. Check whether there is any coolant, and have the cooler serviced. b. Clogging of condenser If there is any dirt or mud stuck to the condenser, there will be a big reduction in the cooling efficiency of the condenser. That will mean a reduc- tion in the cooling capacity, so clean the dirt and mud off and correct any bent fins with a screw-driver. c.
Checking and adjusting V-belt tension The slack should be 10 to 12 mm when pushed with a finger force of about 6 kg midway between the compressor pulley (1) and the crankshaft pulley (2). (3): Tension pulley (4): Water pump pulley (5): Fan pulley (6): Alternator pulley 1. Loosen bolts (7) and (8), and move compressor (9) to adjust. 2. After adjusting, tighten 2 bolts (7) and bolt (8) securely. t When adjusting the V-belt, do not attempt to push compressor (9) directly with a bar or the like, but use a wood pad to prevent damage to the core. - 26 -