EXCAVATOR’S WORK In addition to the following, it is possible to further increase the range of applications by using various attachments. A. BACK HOE WORK A back hoe is suitable for excavation at a position lower than the ma- chine. It is possible to effectively move the arm through 30” in the direction towards the machine and 45” in the direction away from the machine, mak- ing for efficient work. B. SHOVEL WORK (except PC300,3OOLC-5 MIGHTY) A shovel is suitable for excavating at a position higher than the machine. Shovel work is performed by attaching the bucket in the reverse direction. C. LOADING WORK About half of the time spent during excavating and loading work is taken up swinging.
Maximum work efficiency can be attained by carrying out work in such a way that the swinging angle is kept as small as possible in ac- cordance with the terrain. When loading, it is better to fit the machine in the longitudinal direction of the dump truck and to load from the front of the dump truck body. This both faciliates loading and also enables a greater amount of material to be loaded as compared with loading from the side of the truck. D. DITCH DIGGING WORK Ditch digging work can be performed efficiently by attaching a bucket to match the width of the ditch and then setting the tracks parallel to the line of the ditch to be excavated.
To excavate a wide ditch, first dig out both sides and then finally remove the center portion. - 38 -