Komatsu — HANDLING OF BATTERY

C. STARTING ENGINE WITH A BOOSTER CABLE When starting the engine with a booster cable, do as follows: 1. Before connecting the booster cable 1) Size of booster cable and clip should be suitable for the battery size. 2) Check cables and clips for breaks, corroded surfaces, etc. 3) Make sure cables and clips are firmly secured. 4) Keep the starting switch in the “OFF” position. 5) The battery of the running engine must be the same capacity as that of the engine to be started. 2. Connect the booster cables in the following manner. 1) Connect one clip of booster cable (A) to the positive (+) terminal of the engine to be started.

2) Connect the other clip to the positive (+) terminal of the engine which is running. 3) Connect one clip of booster cable (B) to the negative (-) terminal of the engine which is running. 4) Connect the other clip to the engine block to be started. * Make sure the clips are firmly connected to battery terminals. Then, start the engine. (C): Battery for running engine (D): Battery for engine to be started (E): Engine block to be started A When connecting the cables, never contact the positive (+) and negative (-) terminals. A Make sure that the booster cable connections are correct. Connect the booster cable to the engine block as far as possible from the battery. 3.

Starting engine 1) Turn the starting switch to START position and start up the engine. 2) If the engine doesn’t start at first, try again after 2 minutes or so. - 42 -