Komatsu — PRECAUTIONS FOR MAINTENANCE

Method of relieving pressure 1) Lower the work equipment to the ground and stop the engine after id- ling it for two or three minutes. Then operate the various operation le- vers. (work equipment, traveling and steering lever through their full stroke in each direction) When removing air instruments or pipings, open the drain valve under the air reservoir to relieve air pressure. 2) Gradually unscrew the cap of the hydraulic tank and leave it for a few minutes. 13. Flames should never be used instead of lamps. Never use a naked flame to check leaks or the level of oil, fuel, antifreeze or electrolyte. 14.

Immediately remove any oil or grease on the floor of the operator’s compartment, or on the handrail. It is very dangerous if someone slips while on the machine. 15. Be particularly careful when removing the radiator cap. If this is done immediately after using the machine, there is a danger that boiling water may spurt out. 16. Do not check the fan belt tension while the engine is running. Be sure to turn off the engine before inspecting other rotating parts and the vi- cinity thereof. 17. Do not allow anybody other than the necessary workers to go near the machine while it is being inspected or maintained. Also, be careful of people in the vicinity.

It is necessary to exercise particular care when performing grinding or welding, or when swinging a large hammer. 18. Use the tool which is suitable for the maintenance work. 19. Remove the minus terminal from the battery in maintaining the electrical system. 20. When the tracks are removed, never put your fingers between the shoes. 21. When carrying out other difficult maintenance works, carrying them out carelessly can cause unexpected accidents. If you consider the mainten- ance is too difficult, always request Komatsu distributor to carry out it. - 48 -