If the starting motor does not turn even when the starting switch is turned to START position, a possible cause is a disconnection in the wire- shaped fusible link (I), so check and replace if necessary. ELECTRONIC MONITOR AND CONTROL CONSOLE (EMACC) The angle of the monitor panel can be changed to make it easier to see. When changing the angle, use both hands, and always stop the monitor panel at a position where it is held in the notch. * Range of adjustment: 30” (3 stages) CONTROLLERS PUMP CONTROLLER This informs of the location of any abnormality in the electronic control system of the pump. .A 2-digit display (01 - 29) indicates the location of the abnormality.
When the electronic control system is normal, the display in the table is shown. * If a display is given to show an abnormality, see TROUBLE SHOOTING GUIDE. - 40 -