Komatsu — TRANSPORTATION

TRANSPORTATION When transporting the machine, observe the various road rules, road transportation vehicle laws and vehicle limit ordinances, etc. It is a good idea to obtain a special platform for loading and unloading the machine. When it is unavoidably necessary to use a gangplank, however, at the very least observe the following for the sake of safety. 1. Properly apply the brakes on the trailer and insert blocks (a) beneath the tires to ensure that it does not move. Then fix gangplank (b) in line with the centers of the trailer and the machine. * Make sure the gangplank has sufficient width, length and thickness to en- able the machine to be safely loaded and unloaded.

If the gangplank sags appreciably, reinforce it with blocks, etc. * Make angle (c) of the ganplank a maximum of 15”. * Set distance (d) between the gangplanks to match the center of the tracks. A Remove the mud from the undercarriage to prevent the machine from slipping to the side on slopes. Set the travel speed switch to the Lo position. Turn the AUTO-DECEL switch OFF and return the fuel control dial to re- duce the engine speed. Turn the swing lock switch ON to apply the swing lock. Set in the direction of the gangplank, lower the work equipment as far as possible without letting it hit the trailer, then travel slowly to load or un- load the machine.

When on the gangplank, do not operate any lever other than the travel lever. When the work equipment is installed, load the machine from the front; when the work equipment is not installed, load the machine from the rear. A Never change the direction of travel when on the gangplank. If it is necessary to change direction, drive off the gangplank and correct the direction, then drive on to the gangplank again. 2. 3. 4. 5. * * Load the machine correctly in the specified position on the trailer. After loading the machine, fully extend the bucket and arm cylinders, then slowly lower the boom.

When transporting the machine, place rectangular timber under one end of the bucket cylinder to prevent it touching the ground, thereby saving it from possible damage. Lock all the control levers securely with the lock lever. - 88 -