Mack Trucks — PV776-21394653.pdf

Operator’s Manual Vehicle Maintenance CXU, CHU, GU, TD, MRU and LEU 103 W0054014 1. Acceptable (Witness Mark Approximately Same Width as Belt) 2. Not Acceptable (Witness Mark Tracking Off Edge of Pulley) Remove the belt by using a 3/8 inch breaker bar to pull the tensioner back to the install stop. Slowly return the tensioner to the free-arm stop. With the belt removed, use the breaker bar to slowly pull the tensioner from the free-arm stop to the install stop and then slowly releasing it back to the free-arm stop. Any excessive roughness or hesitancy noticed while performing this check indicates that the tensioner must be replaced. Check for metal-to-metal contact as follows:

Main Drive Belt Tensioner Belt Tracking Witness Mark Check for contact between the arm and the spring case. Replace if metal-to-metal contact is seen.