Mack Trucks — PV776-21394653.pdf

Operator’s Manual Vehicle Maintenance CXU, CHU, GU, TD, MRU and LEU 133 Paint and Brightwork Care Cab CAUTION When using a pressure washer to clean the vehicle, do not direct the spray at electrical components in the engine compartment such as the alternator, starter and compressors. Water spray from pressure washers can damage electrical components. Wash all exterior painted surfaces frequently to remove dirt. It is especially important to wash off salt-laden snow and ice during the cold season. A mild detergent approved for automotive cleaning can be used but avoid strong detergents. Note: DO NOT aim the water jet directly at door and window seals or door locks.

If locks are filled with water, use compressed air to clean the water out and then apply liquid graphite. Be especially careful of leaving water in locks or around seals during freezing weather. Apply a coat of wax regularly. This will help the paint and other surfaces keep their luster. If the surface gets dull, use a restoring cleaner specially designed for this. Clean off all tar spots and tree sap before waxing. Chassis Keep the chassis free from buildup of dirt. Make sure the chassis is cleaned before the maintenance inspections to help spotting leaks, etc. As salt can be part of the road sludge during the cold season, remove buildup of snow and ice so it does not promote corrosion.

At the end of the cold season, thoroughly flush away all collected dirt from the chassis. 1 Clean chassis with high pressure water spray. Use mild detergent if available; remove loose dirt and grease. If signs of delamination of the frame rail are apparent, complete the following steps: 2 Continue high pressure wash to affected delamination areas of paint from the frame rails. Apply high pressure spray until paint holds on frame substrates. After completing these steps, to avoid further delamination, have the framerail serviced as soon as possible.