Mack Trucks — PV776-21394653.pdf

Operator’s Manual Vehicle Maintenance CXU, CHU, GU, TD, MRU and LEU 49 The location of the yaw rate/lateral acceleration sensor must not be altered. Aftermarket steering wheels must not be used. Only OEM-supplied replacement steering wheels should be used. During any procedure that involves removal and reinstallation or replacement of the OEM steering wheel, care must be used not to crush or damage the steering angle sensor which is mounted on the steering column. Increasing steering angle beyond maximum is NOT permitted. However, steering angles may be increased to the maximum factory settings if required. Refer to the applicable steering system service manual for detailed information.

The steering angle sensor must be recalibrated following any adjustments or changes to the steering system. Changing steer axle and/or drive axle track width is permissible. Changing front or rear axle brake drums to drums having a different flange thickness is permissible. The ABS with ESP ECU requires a precise rolling circumference ratio between the front steer axle and the rear drive axles for optimum performance of the system. For this reason, the system continuously calculates the precise ratio and stores the information in the ECU memory. CAUTION Effectiveness of the RSA system relies on the accuracy of the reported vehicle speed.

If major changes to tire sizes are made, such that changes to the vehicle speedometer/odometer settings are required, the ABS with ESP ECU must be reprogrammed with the new values by a qualified technician.