Mack Trucks — PV776-21394653.pdf

56 Operator’s Manual Vehicle Maintenance CXU, CHU, GU, TD, MRU and LEU MACK low cab forward models (MRU, LEU) utilize a surge tank which is located on the left-hand side of the chassis, mounted on a stanchion to the rear of the cab. This surge tank utilizes a standard radiator pressure cap. Check the coolant level regularly, making sure the coolant is visible in the sight glass located on the side of the tank. At each C and D inspection interval, remove the radiator cap and inspect the gasket for any defects that would affect sealing. Also, pressure-test the cap using a suitable cooling system and radiator cap tester. Surge tank cap pressure specifications are as follows:

MP7 Engines (MRU and LEU Models) 16-lb. pressure cap MP8 Engines (MRU Models only) 16-lb. pressure cap The main purpose of coolant is to transport heat from the hot parts of the engine to the radiator and to protect the cooling system from corrosion. In addition to this, the coolant must: Protect against pitting and cavitation erosion damage of the water pump and cylinder liners. Protect against freezing and boiling. Prevent formation of scale, sludge deposits and clogging. Be harmless to polymer materials and seals in the cooling system. Maintain its liquid properties in cold climates. Many engine failures can be traced back to a problem in the cooling system.

If the coolant level is allowed to go below the bottom of the tank, there is the risk of the engine shutting down. See the operators manual for more information on the warning functions. WARNING DO NOT remove the fill cap while the cooling system is hot. Allow the system to cool sufficiently before removing. Turn the fill cap slowly counterclockwise to the first stop, and then wait for the pressure in the system to dissipate. After the pressure has dissipated, completely remove the cap.